English
 
User Manual Privacy Policy Disclaimer Contact us
  Advanced SearchBrowse

Item

ITEM ACTIONSEXPORT
  Residual stresses in thermally cycled CrN coatings on steel

Kirchlechner, C., Martinschitz, K. J., Daniel, R., Mitterer, C., & Kečkéš, J. (2008). Residual stresses in thermally cycled CrN coatings on steel. Thin Solid Films, 517(3), 1167-1171. doi:10.1016/j.tsf.2008.06.008.

Item is

Basic

show hide
Item Permalink: http://hdl.handle.net/11858/00-001M-0000-001A-2557-F Version Permalink: http://hdl.handle.net/11858/00-001M-0000-001A-2559-B
Genre: Journal Article
Alternative Title :

Files

show Files

Locators

show

Creators

show
hide
 Creators:
Kirchlechner, C.1, 2, Author              
Martinschitz, K. J.1, 2, Author              
Daniel, R.3, Author              
Mitterer, C.3, Author              
Kečkéš, J.1, 2, Author              
Affiliations:
1Department of Materials Physics, Montanuniversität Leoben, Leoben, Austria, ou_persistent22              
2Erich Schmid Institute for Materials Science, Austrian Academy of Sciences, Austria, ou_persistent22              
3Department of Physical Metallurgy and Materials Testing, University of Leoben, Christian-Doppler Laboratory for Advanced Coatings, Austria, ou_persistent22              

Content

show
hide
Free keywords: -
 Abstract: CrN coatings were deposited on polycrystalline ferritic steel substrates at 350°C by magnetron sputtering using Cr targets in Ar + N2 atmosphere. In order to simulate the thermal fatigue, the samples were repeatedly irradiated using a laser beam of 6mm in diameter. The thermal cycling was performed in the range of 50–650°C with up to 100 000cycles. Subsequently, the structures were characterized using high-energy synchrotron and high-temperature laboratory X-ray diffraction. The structures exhibit complex changes in the morphology and in residual stress state in the heated spot. The annealing results in the relaxation of compressive stresses in the coating and in the formation of high tensile stresses in the steel substrate. This effect decisively depends on the number of applied cycles. The reduction of compressive stress in the coating is caused by the annealing of point defects and by dimensional changes of the substrate due to its plastic deformation in the center of the irradiated spot. The plastic deformation of the substrate is also the probable reason for the ripples observed for samples cycled more than 3000 times. The presented approach allows a complex characterization of thermo-mechanical processes in coating-substrate composites and opens the possibility to understand phenomena related to the thermal fatigue of coated tools.

Details

show
hide
Language(s): eng - English
 Dates: 2008-12-01
 Publication Status: Published in print
 Pages: -
 Publishing info: -
 Table of Contents: -
 Rev. Method: -
 Identifiers: DOI: 10.1016/j.tsf.2008.06.008
 Degree: -

Event

show

Legal Case

show

Project information

show

Source 1

show
hide
Title: Thin Solid Films
Source Genre: Journal
 Creator(s):
Affiliations:
Publ. Info: Lausanne, Switzerland, etc. : Elsevier
Pages: - Volume / Issue: 517 (3) Sequence Number: - Start / End Page: 1167 - 1171 Identifier: ISSN: 0040-6090
CoNE: /journals/resource/954925449792