English
 
Help Privacy Policy Disclaimer
  Advanced SearchBrowse

Item

ITEM ACTIONSEXPORT

Released

Journal Article

Thermographic observation of the divertor target plates in the stellarators W7-AS and W7-X

MPS-Authors
/persons/resource/persons109390

Hildebrandt,  D.
Plasma Diagnostics Group (HUB), Max Planck Institute for Plasma Physics, Max Planck Society;

/persons/resource/persons109226

Grigull,  P.
W7-X: Physics (PH), Max Planck Institute for Plasma Physics, Max Planck Society;

/persons/resource/persons109914

McCormick,  K.
Stellarator Scenario Development (E5), Max Planck Institute for Plasma Physics, Max Planck Society;
W7-AS, Max Planck Institute for Plasma Physics, Max Planck Society;

/persons/resource/persons110035

Naujoks,  D.
Plasma Diagnostics Group (HUB), Max Planck Institute for Plasma Physics, Max Planck Society;

/persons/resource/persons110604

Sünder,  D.
Plasma Diagnostics Group (HUB), Max Planck Institute for Plasma Physics, Max Planck Society;
Experimental Plasma Physics 3 (E3), Max Planck Institute for Plasma Physics, Max Planck Society;

W7-AS Team, 
Max Planck Institute for Plasma Physics, Max Planck Society;

External Resource
No external resources are shared
Fulltext (restricted access)
There are currently no full texts shared for your IP range.
Fulltext (public)
There are no public fulltexts stored in PuRe
Supplementary Material (public)
There is no public supplementary material available
Citation

Hildebrandt, D., Gadelmeier, F., Grigull, P., McCormick, K., Naujoks, D., Sünder, D., et al. (2003). Thermographic observation of the divertor target plates in the stellarators W7-AS and W7-X. Journal of Nuclear Materials, 313-316, 738-742. doi:10.1016/S0022-3115(02)01490-3.


Cite as: https://hdl.handle.net/11858/00-001M-0000-0027-232B-C
Abstract
Thermography is applied on the stellarator W7-AS to monitor the thermal load of the recently installed divertor targets. A three dimensional numerical code was developed to evaluate power fluxes arriving at the targets from the measured temporal evolution of the surface temperature distribution. Values of the thermal conductivity of the used CFC-target material for all three directions are required for this evaluation and determined by observing the propagation of controlled heat pulses applied by an infrared laser. The evaluation of the thermographic measurements during plasma operation shows characteristic spatial and temporal features of the arrived heat fluxes. Significant features in high density regimes like plasma detachment from the divertor target plates or strongly enhanced localised plasma radiation (MARFE) has been observed by the installed infrared cameras. The implications of these observations for the thermographic system for W7-X are shortly addressed.