Creep strength of a binary Al62Ti38 alloy

Sturm, D.; Heilmaier, M.; Saage, H.; Aguilar, J.; Schmitz, G. J.; Drevermann, A.; Palm, M.; Stein, F.; Engberding, N.; Kelm, K.; Irsen, S.

Item

ITEM ACTIONSEXPORT

Add to Basket

Local TagsRelease HistoryDetailsSummary

Released

Journal Article

Creep strength of a binary Al62Ti38 alloy

MPS-Authors

/persons/resource/persons135043

Kelm, K.
Center for Materials Analysis, Technische Fakultät, Christian-Albrechts-Universität Kiel, Kaiserstraße 2, D-24143 Kiel, Germany ;
Electron Microscopy and Analytics, Center of Advanced European Studies and Research (caesar), Max Planck Society;
Stiftung caesar, Electron Microscopy, Bonn, Germany ;

/persons/resource/persons182739

Irsen, S.
Electron Microscopy and Analytics, Center of Advanced European Studies and Research (caesar), Max Planck Society;

External Resource

No external resources are shared

Fulltext (restricted access)

There are currently no full texts shared for your IP range.

Fulltext (public)

There are no public fulltexts stored in PuRe

Supplementary Material (public)

There is no public supplementary material available

Citation

Sturm, D., Heilmaier, M., Saage, H., Aguilar, J., Schmitz, G. J., Drevermann, A., et al. (2010). Creep strength of a binary Al62Ti38 alloy. International Journal of Materials Research, 101(5), 676-679.

Cite as: https://hdl.handle.net/11858/00-001M-0000-0028-60EA-2

Abstract

Al-rich Ti-Al alloys, as compared to Ti-rich gamma-TiAl-based alloys, offer an additional reduction in density of 20%, better oxidation resistance and sufficient strength at high temperatures. High temperature creep of a binary Al62Ti28 alloy was studied in compression in the temperature range between 1173 K and 1323 K in air. It is shown that the alloy exhibits quite reasonable creep resistance at 1173 K, especially in view of its low density of around 3.8 g cm(-3). Stress exponents calculated as the slope n = Delta log (strain rate)/Delta log (stress) = 4 were found to be relatively constant for the temperature and stress regime investigated. This indicates that dislocation climb may be the rate controlling creep mechanism. The values of the activation energies for creep for the as-cast and the annealed Al62Ti38 material coincides well with those found in the literature for interdiffusion of Al in gamma-TiAl