English
 
Help Privacy Policy Disclaimer
  Advanced SearchBrowse

Item

ITEM ACTIONSEXPORT

Released

Journal Article

On the influence of the aliphatic linker on fabrication of highly ordered and orientated self-assembled monolayers of aromatic selenols on AU(111)

MPS-Authors
/persons/resource/persons125042

Bashir,  Asif
Corrosion, Interface Chemistry and Surface Engineering, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

External Resource
No external resources are shared
Fulltext (restricted access)
There are currently no full texts shared for your IP range.
Fulltext (public)
There are no public fulltexts stored in PuRe
Supplementary Material (public)
There is no public supplementary material available
Citation

Azzam, W., Al-Rawashdeh, N. A., Al-Refaie, N., Shekhah, O., & Bashir, A. (2014). On the influence of the aliphatic linker on fabrication of highly ordered and orientated self-assembled monolayers of aromatic selenols on AU(111). The Journal of Physical Chemistry C, 118(9), 4846-4859. doi:10.1021/jp500069g.


Cite as: https://hdl.handle.net/21.11116/0000-0001-C0AD-3
Abstract
Self-assembled monolayers (SAMs) formed by adsorption of 1,2-dibenzyldiselenide (DPMSe) and 1,2-diphenyldiselenide (DBSe) on Au(111) substrates at room temperature have been characterized using scanning tunnelling microscopy, X-ray photoelectron spectroscopy, infrared reflection absorption spectroscopy, near-edge X-ray absorption fine structure spectroscopy, and low-energy electron diffraction. Upon adsorption, the Se-Se bonds in DPMSe and DBSe were cleaved on the gold surface to form phenylmethaneselenolate (PMSe) and benzeneselenolate (BSe) species, respectively. Although both PMSe and BSe molecular entities only differ in their structure (an additional methyl group in PMSe), the resulting monolayer films revealed noteworthy dissimilarities regarding their adlayer SAM structure and surface morphology. The molecular adlayer structure and orientation of PMSe and BSe species were found to vary significantly with the immersion time (IT). The resulting PMSe films were poorly organized, and the structure was described by a (4√3 × 2) rectangular unit cell for the SAMs prepared with 24 h of IT. Moreover, the PMSe-SAMs were found to be unstable upon exposure to air for a long time. Our results showed that exposure to air for 48 h results in the formation of small bright ad-islands, which have a height corresponding to that of a single atomic step on the Au(111). Contrary, BSe-SAMs exhibited densely packed and well-ordered monolayers, and two different structural phases were resolved at short and long ITs. The most densely packed structure was obtained for SAMs prepared with very short ITs (10 min). Upon increasing the IT, the SAMs exhibited structural changes to a lower density of molecular packing structure. The spectroscopic data also confirmed this structural transformation by suggesting an upright orientation for BSe-SAMs prepared after short ITs and strongly inclined adsorption geometry for SAMs prepared after long ITs. © 2014 American Chemical Society.