English
 
Help Privacy Policy Disclaimer
  Advanced SearchBrowse
  1. View item / 
  2. Item Summary

Item

ITEM ACTIONSEXPORT
Add to Basket
  Local TagsRelease HistoryDetailsSummary

Released
Journal Article

Understanding hot vs. Cold rolled medium manganese steel deformation behavior using in situ microscopic digital image correlation

MPS-Authors
/persons/resource/persons221872

Dutta,  Aniruddha
Mechanism-based Alloy Design, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

/persons/resource/persons125320

Ponge,  Dirk
Mechanism-based Alloy Design, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

/persons/resource/persons125330

Raabe,  Dierk
Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

External Resource
No external resources are shared
Fulltext (restricted access)
There are currently no full texts shared for your IP range.
Fulltext (public)
There are no public fulltexts stored in PuRe
Supplementary Material (public)
There is no public supplementary material available
Citation

Dutta, A., Ponge, D., Sandlöbes, S., & Raabe, D. (2018). Understanding hot vs. Cold rolled medium manganese steel deformation behavior using in situ microscopic digital image correlation. Materials Science Forum, 941, 198-205. doi:10.4028/www.scientific.net/MSF.941.198.


Cite as: https://hdl.handle.net/21.11116/0000-0003-A293-F
Abstract
We address the differences in yield stresses between hot and cold rolled medium manganese steel showing continuous yielding. Continuous yielding in both, the hot and cold rolled samples were resulting from reverted austenite islands plastically deforming first and less strain in the tempered martensite matrix. At higher global strains, strain was taken up not only by the reverted austenite, but also by tempered martensite and fresh martensite formed from the austenite through martensitic phase transformation during deformation. Strain localization was also observed in the hot rolled samples. This localization is caused by cumulative deformation of colonies of lamellar reverted austenite islands. It is interpreted in terms of the spatial alignment of austenite colonies to the loading direction in addition to the crystallographic orientation. © 2018 Trans Tech Publications, Switzerland.