Solute hydrogen and deuterium observed at the near atomic scale in 
high-strength steel

Breen, Andrew J.; Stephenson, Leigh; Sun, Binhan; Li, Yujiao; Kasian, Olga; Raabe, Dierk; Herbig, Michael; Gault, Baptiste

doi:10.1016/j.actamat.2020.02.004

Datensatz

DATENSATZ AKTIONENEXPORT

Zur Ablage hinzufügen

Lokale TagsFreigabegeschichteDetailsÜbersicht

Freigegeben

Zeitschriftenartikel

Solute hydrogen and deuterium observed at the near atomic scale in high-strength steel

MPG-Autoren

/persons/resource/persons172964

Breen, Andrew J.
Atom Probe Tomography, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;
Australian Centre for Microscopy and Microanalysis, University of Sydney, NSW, Australia;
School of Aerospace, Mechanical and Mechatronic Engineering, University of Sydney, NSW, Australia;

/persons/resource/persons208581

Stephenson, Leigh
Atom Probe Tomography, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;
Hydrogen in Energy Materials, Project Groups, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

/persons/resource/persons229256

Sun, Binhan
Mechanism-based Alloy Design, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

/persons/resource/persons188367

Kasian, Olga
Electrocatalysis, Interface Chemistry and Surface Engineering, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;
Helmholtz Zentrum Berlin, Helmholtz-Institute Erlangen-Nürnberg, 14109 Berlin, Germany;

/persons/resource/persons125330

Raabe, Dierk
Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

/persons/resource/persons125176

Herbig, Michael
Materials Science of Mechanical Contacts, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

/persons/resource/persons185411

Gault, Baptiste
Atom Probe Tomography, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;
Hydrogen in Energy Materials, Project Groups, Microstructure Physics and Alloy Design, Max-Planck-Institut für Eisenforschung GmbH, Max Planck Society;

Externe Ressourcen

Es sind keine externen Ressourcen hinterlegt

Volltexte (beschränkter Zugriff)

Für Ihren IP-Bereich sind aktuell keine Volltexte freigegeben.

Volltexte (frei zugänglich)

Es sind keine frei zugänglichen Volltexte in PuRe verfügbar

Ergänzendes Material (frei zugänglich)

Es sind keine frei zugänglichen Ergänzenden Materialien verfügbar

Zitation

Breen, A. J., Stephenson, L., Sun, B., Li, Y., Kasian, O., Raabe, D., et al. (2020). Solute hydrogen and deuterium observed at the near atomic scale in high-strength steel. Acta Materialia, 188, 108-120. doi:10.1016/j.actamat.2020.02.004.

Zitierlink: https://hdl.handle.net/21.11116/0000-0005-D9A6-B

Zusammenfassung

Observing solute hydrogen (H) in matter is a formidable challenge, yet, enabling quantitative imaging of H at the atomic-scale is critical to understand its deleterious influence on the mechanical strength of many metallic alloys that has resulted in many catastrophic failures of engineering parts and structures. Here, we report on the APT analysis of hydrogen (H) and deuterium (D) within the nanostructure of an ultra-high strength steel with high resistance to hydrogen embrittlement. Cold drawn, severely deformed pearlitic steel wires (Fe–0.98C–0.31Mn–0.20Si–0.20Cr–0.01Cu–0.006P–0.007S wt, ε=3.1) contains cementite decomposed during the pre-deformation of the alloy and ferrite. We find H and D within the decomposed cementite, and at some interfaces with the surrounding ferrite. To ascertain the origin of the H/D signal obtained in APT, we explored a series of experimental workflows including cryogenic specimen preparation and cryogenic-vacuum transfer from the preparation into a state-of-the-art atom probe. Our study points to the critical role of the preparation, i.e. the possible saturation of H-trapping sites during electrochemical polishing, how these can be alleviated by the use of an outgassing treatment, cryogenic preparation and transfer prior to charging. Accommodation of large amounts of H in the under-stoichiometric carbide likely explains the resistance of pearlite against hydrogen embrittlement. © 2020 Acta Materialia Inc.