English
 
Help Privacy Policy Disclaimer
  Advanced SearchBrowse

Item

ITEM ACTIONSEXPORT
Add to Basket
  Local TagsRelease HistoryDetailsSummary

Released
Journal Article

Development of a single crystal sample holder for interfacing ultrahigh vacuum and electrochemical experimentation

MPS-Authors
/persons/resource/persons244746

Bruce,  Jared P.
Interface Science, Fritz Haber Institute, Max Planck Society;

/persons/resource/persons261323

Nguyen,  Khanh-Ly Claudia
Interface Science, Fritz Haber Institute, Max Planck Society;

/persons/resource/persons227612

Scholten,  Fabian
Interface Science, Fritz Haber Institute, Max Planck Society;

/persons/resource/persons227595

Aran Ais,  Rosa
Interface Science, Fritz Haber Institute, Max Planck Society;

/persons/resource/persons227635

Navarro,  Juan Jesus
Interface Science, Fritz Haber Institute, Max Planck Society;

/persons/resource/persons21603

Hartmann,  Jens
Interface Science, Fritz Haber Institute, Max Planck Society;

/persons/resource/persons21628

Heyde,  Markus
Interface Science, Fritz Haber Institute, Max Planck Society;

/persons/resource/persons22020

Roldan Cuenya,  Beatriz
Interface Science, Fritz Haber Institute, Max Planck Society;

External Resource
No external resources are shared
Fulltext (restricted access)
There are currently no full texts shared for your IP range.
Fulltext (public)

5.0057822.pdf
(Publisher version), 11MB

Supplementary Material (public)
There is no public supplementary material available
Citation

Bruce, J. P., Nguyen, K.-L.-C., Scholten, F., Aran Ais, R., Navarro, J. J., Hartmann, J., et al. (2021). Development of a single crystal sample holder for interfacing ultrahigh vacuum and electrochemical experimentation. Review of Scientific Instruments, 92(7): 074104. doi:10.1063/5.0057822.


Cite as: https://hdl.handle.net/21.11116/0000-0008-E284-3
Abstract
Electrocatalyst surfaces prepared under ultrahigh vacuum (UHV) conditions can create model surfaces to better connect theoretical calculations with experimental studies. The development of a single crystal sample holder and inert electrochemical cells prepared with modularity and chemical stability in mind would allow for expensive single crystals to be reused indefinitely in both UHV and electrochemical settings. This sample holder shows reproducible surface preparations for single crystal samples and consistent electrochemical experiments without the introduction of impurities into the surface. The presented setup has been used as a critical piece for the characterization of Cu(111) surfaces under CO2 electrochemical reduction reaction conditions as a test case.